Sony Ericsson GM47 - AT*E2 NMPR Ericsson M2 M Set NMEA (GPS) Port Rate

GM47/GM48 INTEGRATOR’S MANUAL
182
LZT 123 7263 R1A
9.2 AT*E2NMPR Ericsson M2M Set NMEA (GPS) Port Rate
This command allows the user to set the physical Data rate for the GPS/
NMEA port. The port rate will be set for the GPS/NMEA port only
when NMEA is active - see AT*EENMEA.
Examples
AT*E2NMPR=?
*E2NMPR=(0,1,2,3,4,5,6,7,8,9,10)
OK
Port rate currently set:
<mode> Description
0 Disable NMEA communication. Default
1 Enable NMEA communication in NMEA “only” mode. Not
supported
2 Enable NMEA communication simultaneously with AT
commands
Description Command Possible Responses
Request operation to
set data rate for GPS/
NMEA Port
AT*E2NMPR=<pr> •ERROR
•OK
Displays current setting AT*E2NMPR? *E2NMPR: <pr>
Show if the command
is supported
AT*E2NMPR=? •*E2NMPR:(listof
supported <pr>s)
•ERROR
<op> Description
o 600 Baud rate
1 1200 Baud rate
2 2400 Baud rate
3 4800 Baud rate
4 9600 Baud rate. Default setting
5 19200 Baud rate
6 38400 Baud rate
7 57600 Baud rate
8 115200 Baud rate
9 230400 Baud rate
10 460800 Baud rate