Sony Ericsson GM47 - AT+CGDCONT: Define PDP Context Parameters

GM47/GM48 INTEGRATOR’S MANUAL
154
LZT 123 7263 R1A
6.4 AT+CGDCONT Define PDP Context
Specifies PDP context parameter values for a PDP context identified by
the (local) context identification parameter, <cid>.
Description Command Possible Responses
Select PDP
context
parameters
+CGDCONT=[<cid>
[,<PDP_type> [,<APN>
[,<PDP_addr>
[,<d_comp>
[,<h_comp> [,<pd1>
[,…[,pdN]]]]]]]]]
• +CME ERROR: <err>
•OK
• ERROR
Read the
command
+CGDCONT? • +CGDCONT: <cid>,
<PDP_type>,<APN>,
<PDP_addr>,<d_comp>,
<h_comp>[,<pd1>[,…[,pdN]]]
[<CR><LF>+CGDCONT:
<cid>, <PDP_type>,<APN>,
<PDP_addr>,<d_comp>,
<h_comp>[,<pd1>[,…[,pdN]]]
[...]]
•OK
• ERROR
Test if the
command is
supported
+CGDCONT=? •+CGDCONT:(rangeof
supported <cid>s),
<PDP_type>,,,(list of
supported <d_comp>s),
(list of supported <h_comp>s)
[,(list of supported <pd1>s)
[,…[,(list of supported
<pdN>s)]]]
[<CR><LF>+CGDCONT:
(range of supported <cid>s),
<PDP_type>,,,(list of
supported <d_comp>s),
(list of supported <h_comp>s)
[,(list of supported
<pd1>s)[,…[,(list of supported
<pdN>s)]]] [...]]
•OK
• ERROR
<cid> Description
Integer type (PDP Context Identifier) a numeric parameter which
specifies a particular PDP context definition. The
parameter is local to the TE-MS interface and is used in
other PDP context-related commands. The range of
permitted values (minimum value = 1) is returned by the
test form of the command
1-10 Supported values. Ericsson specific
<PDP_type> Description
X25 ITU-T/CCITT X.25 layer 3. Not supported
IP Internet Protocol (IETF STD 5)
OSPIH Internet Hosted Octet Stream Protocol. Not supported
PPP Point to Point Protocol (IETF STD 51). Not supported