Sony Ericsson GM47 - Control and Status AT Commands; ATQ: Result Code Suppression Settings; ATS0: Automatic Answer Control Configuration

95
LZT 123 7263 R1A
3. Control and Status
3.1 ATQ Result Code Suppression
Determines whether or not the DCE transmits result codes to the DTE.
When result codes are being suppressed, noportion of any intermediate,
final, or unsolicited result code - header, result text, line terminator, or
trailer - is transmitted.
Note! The Ingo-module triggers on the response from ref. Point E. It is
therefore not possible to turn off the response in ref. Point E.
3.2 ATS0 Automatic Answer Control
Defines the automatic answering feature of the modem. A non-zero
value specifies the number of rings before the call is answered.
Description Command Possible Responses
Set Result Code
Suppression
ATQ[=]<value> •OK
•ERROR
Read the current
setting
ATQ? Q: <value>
Show if the command
is supported
ATQ=? Q: (list of supported
<value>s)
<value> Description
0 DCE transmits result codes. Default value
1 Result codes are suppressed and not transmitted
Description Command Possible Responses
Automatic answer
control
ATS0=[<rcnt>] •OK
•ERROR
Read the current
setting
ATS0? <rcnt>
Show if the command
is supported
ATS0=? S0: (list of supported
<rcnt>s)