Sony Ericsson GM47 - At+Cpas; Phone Activity Status

3. CONTROL AND STATUS
111
LZT 123 7263 R1A
3.26 AT+CPAS Phone Activity Status
Returnsthe activity status <pas> of the ME. It can be used to interrogate
the ME before requesting action from the phone.
When the command is executed without the <mode> argument, the
command returns <pas>-values from 0 to 128 (for supported values se
table 1 below). When, on the other hand, the command is executed with
the <mode> argument set to 1, the command may return Ericsson
specific <pas> values from 129 to 255 (for supported values see the
table below).
<disp> Description
0 No display event reporting
<ind> Description
0 No indicator event reporting
1 Indicator event reporting using result code +CIEV:
<ind>,<value>.<ind>indicatesthe indicatororder number
(asspecifiedfor+CIND)and<value>isthenewvalueof
indicator. Only those indicator events, which are not
caused by +CIND shall be indicated by the TA to the TE
2 Not Supported
<bfr> Description
0 TA buffer of unsolicited result codes defined within this
command is cleared when <mode> 1...3 is entered
1 TA buffer of unsolicited result codes defined within this
command is flushed to the TE when <mode> 1...3 is
entered (OK response shall be given before flushing the
codes). Not Supported
Description Command Possible Responses
Execute Phone Activity
Status
AT+CPAS[=<mode>] •+CPAS:<pas>
• +CME ERROR <err>
•OK
•ERROR
Test if the command is
supported
AT+CPAS=? •+CPAS:
(list of supported
<pas>s)
• +CME ERROR <err>
•OK
•ERROR