GM47/GM48 INTEGRATOR’S MANUAL
86
LZT 123 7263 R1A
2.3 ATD Dial
Used to initiate a phone connection, which may be data or voice (phone
number terminated by semicolon). The phone number used to establish
the connection will consist of digits and modifiers, or a stored number
specification.
If the dial string is followed by a semicolon this informs the phone that
the number is a voice rather than a data number.
If the dial string is omitted, and the semicolon included, the command
instructs the ME to do a network detect. If the network is available OK
is returned.
Abortability:
Aborting an ATD command is accomplished by the transmission from
the DTE to the DCE of any character. A single character shall be
sufficient to abort the command in progress; however, characters
Description Syntax Possible Responses
• Originate a call and
dial the phone
number specified in
the command as
<dial_string>
or
•Doanetwork
detect
ATD<dial_string>[;] •CONNECT
•CONNECT<text>
• NO CARRIER
•ERROR
•NODIALTONE
•BUSY
•OK
Dialthe phone number
stored in the mobile
phone which is
located by the index
<I>
ATD>ME<I>[;] •CONNECT
•CONNECT<text>
• NO CARRIER
•ERROR
•NODIALTONE
•BUSY
•OK
Dialthe phone number
stored in the SIM card
whichislocatedby the
index <I>
ATD>SM<I>[;] •CONNECT
•CONNECT<text>
• NO CARRIER
•ERROR
•NODIALTONE
•BUSY
•OK
Dialthe phone number
stored in the Last
dialled number list on
the SIM card, which is
located by the index
<I>
The most recently
dialled number is
assumed to have
<I>="1"
ATD>LD<I>[;] •CONNECT
•CONNECT<text>
• NO CARRIER
•ERROR
•NODIALTONE
•BUSY
•OK
Redial the last phone
number dialled.
Ericsson specific
ATDL[;] ...
To Next Page
Loading...
