Sony Ericsson GM47 - ATS5 Command Line Editing Character (BACKSPACE); ATS6 Blind Dial Delay Control

GM47/GM48 INTEGRATOR’S MANUAL
98
LZT 123 7263 R1A
3.6 ATS5 Command Line Editing Character (BACKSPACE)
This S-parameter represents the decimal IA5 value of the character
recognised by the DCE as a request to delete from the command line the
immediately preceding character.
3.7 ATS6 Blind Dial Delay Control
Defines the number of seconds to wait before call addressing when a
dial tone is not detected. This command is ignored by the Infrared
Modem and is only included for compatibility.
Description Command Possible Responses
Request Command
Line Editing Character
ATS5=<value> •OK
•ERROR
Shows the current
setting
ATS5? <value>
Show if the command
is supported
ATS5=? S5: (list of supported
<value>s)
<value> Description
8 Line editing character. Default value
0 to 127 Line editing character
Description Command Possible Responses
Blind dial delay control ATS6=[<dly>] OK
Read the current
setting
ATS6? <dly>
Show if the command
is supported
ATS6=? S6: (list of supported
<dly>s)
<dly> Description
2 Wait two seconds before blind dialling.Default value.
2-255 Number of seconds to wait before blind dialling