70
System Configuration Menu
Chapter 3 Menu
Network
Name Sets the information for the administration (device ID).
When the item is selected, you can enter a new name.
New Name: Enter a new name (up to 20 characters).
Location Sets the location information.
When the item is selected, you can enter a new name.
New Name: Enter a new name (up to 20 characters).
Trap Sets the address to send the information.
Mode Sets the settings to send information manually or automatically ([Manual] or Auto).
Trap Address Setting Sets the IP address to send the information. [000.000.000.000]
When Mode is set to Manual, you can select this item.
When the item is selected, you can set the IP address of Trap1 to Trap4.
Cancel: Cancels the changed or confirmed setting.
Confirm: Saves the changed or confirmed setting.
Trap Address Status Displays the IP address to send the information.
When Mode is set to Auto, you can select this item.
When the item is selected, the IP address of Trap1 to Trap4 is displayed.
Reset Mode/Address Resets the settings to send information manually or automatically and the IP address to the
factory setting.
When the item is selected, the following message appears.
Are you sure?
OK: To reset the data, press the ENTER (Ent) button.
Cancel: To cancel, press the MENU button.
Authentication Sets whether or not to issue the authentication ([Disable] or Enable).
Community Sets the community name.
When the item is selected, you can enter the community name (up to 20 characters).
public: Initially, public is entered automatically. Enter any character after it.
New Name: Enter a community name.
Protocol Setting Sets the required items for communications such as the port number.
For the setting value, consult the network administrator.
SDCP/SDAP Community Sets the SDCP/SDAP community name.
When the item is selected, you can enter the community name (four characters).
SONY: SONY is entered as a community name.
New Name: Enter a new name.
SDCP Port No Sets the SDCP port number.
Set to 53434 to 53534. [53484]
SDAP Port No Sets the SDAP port number.
Set to 53812 to 53912. [53862]
SDAP Broadcast Sets whether or not to issue the SDAP (Disable or [Enable]).
SDAP Broadcast Period Sets the period (seconds) to issue the SDAP.
Set to 05 to 30. [15]
Acceptable IP Address Sets the IP address to connect.
When the item is selected, you can set IP1 to IP4.
Cancel: Cancels the changed or confirmed setting.
Confirm: Saves the changed or confirmed setting.
Reset Protocol Setting Resets the protocol setting.
When the item is selected, the following message appears.
Are you sure?
OK:
To reset data, press the ENTER (Ent) button.
Cancel: To cancel, press the MENU button.
Parallel Remote Sets the parallel remote function.
Parallel Remote Selects whether or not to use the parallel remote functions. ([Off] or On)
Menu Function and operation ([ ]: factory setting)
To Next Page
Loading...
