Sony DCR-VX2000 - Page 150

Troubleshooting
Symptom Cause and/or Corrective Actions
The photo save function • Tile write-protect tab on the "Memory Stick" is set to LOCK.
does not work. -) Set the tab to write. (p. 115)
• Tile battery pack is dead.
-) Install a charged battery pack or use tile AC power
adaptor instead of the battery pack. (p. 9, 13)
Symptom Cause and/or Corrective Actions
The title is not recorded. • Tile tape has no cassette memory.
-_ Use a tape with cassette memory. (p. 97, 143)
• Tile cassette memory is full.
-_ Erase unnecessary title. (p. 100)
• Tile tape is set to prevent accidental erasure.
-_ Slide the write-protect tab so that red portion is not
visible. (p. 14)
• Nothing is recorded in that position on tile tape.
-_ Superimpose tile title to the recorded position. (p. 97)
• Tile tape has no cassette memory.
-_ Use a tape with cassette memory. (p. 103, 143)
• Tile cassette memory is full.
÷ Erase some data. (p. 105)
• Tile tape is set to prevent accidental erasure.
-_ Slide the write protect tab so that red portion is not
visible. (p. 14)
÷ Disconnect the i.LINK cable (DV connecting cable), and
connect it again. (p. 74)
Tile cassette label is not
recorded.
While editing using tile
i.LINK cable (DV connecting
cable), recording picture
cannot be monitored.
Digital program editing
does not fimction.
• Tile input selector on tile VCR is not set correctly.
-) Check the connection and set up the selector position.
(p. 73)
• Tile camcorder is not connected to Sony DV equipment.
") Set CONTROL to IR in the menu settings and set tile
recording VCR to be controlled by infrared rays.
• Setting program on a blank portion of the tape is attempted.
-) Set tile program again on a recorded portion. (p. 84)
• Your camcorder and the VCR are not synchronized.
-) Synchronize them. (p. 81)
150