Sony DCR-VX2000 - Page 65

Searching for a recording by index - Index search
In the _ mark
• Tile bar in tile _ mark indicates tile present point on tile tape.
• Tile v mark in tile _ indicates tile actual point you are trying to search for.
If a tape has a blank portion between recorded portions
Tile index sear('rn flmction may not work correctly.
If you mark an index onto an external input signal
"LINE" appears in tile CH colunm.
(1) Set tile POWER switch to VCR. >
Q.
(2) Set CM SEARCH in _ to OFF in the menu settings (p. 107). If using a tape <
without cassette memory, skip this step.
CD
(3) Press SEARCH MODE on the Remote Commander repeatedly, until the index
search indicator appears. ,_
The indicator changes as follows:
INDEX SEARCH ---+DATE SEARCH ---+ PHOTO SEARCH ---+ PHOTO SCAN _-O
---+no indicator
(4) Press _ on the Remote Commander to search for the previous index point
or press _ on the Remote Commander to search for the next index point. _
Your camcorder automatically starts playback at the selected index point. Each
time you press _ or I_1, your camcorder searches for the previous or next
index point.
To stop searching
Press I.
65