Audio dubbing
You can record all audio sound to add to tile original sound on a tape by connecting
audio equipment or a microphone. If you connect audio equipment, you can add sound
to your recorded tape by specifying the starting and ending points. Tile original sound
will not be erased. You call also use the Remote Commander for this operation.
MIC (PLUG IN POWER)
MICo oLINE
Set the MIC/LINE
switch to MIC.
z2am
: Signal flow Microphone (not supplied)
You can check the picture on TV by connecting with the vkteo jack. You cannot monitor
the additional sound by tile speaker. Use the headphone jack.
MICo oLINE
Audio equipment
(not supplied)
Set tile MIC/LINE ]
switch to LINE. MIC (PLUG IN LINE OUT
POWER) k @ @ R
I
: Signal flow-
93
To Next Page
Loading...
