Sony DVW-250 - Fixture

1-26
DVW-250/250P
1-14-2. Fixture
n
The fixtures fig. No. 23 and later are not used in this manual.
If used, refer to the Maintenance Manual Part2 Vol-1.
Fig. No. Part No. Description For use
1 J-6001-820-A Upper Drum Eccentricity Adjustment Tool(3) Upper drum eccentricity adjustment
2 J-6001-830-A Upper Drum Eccentricity Adjustment Tool(2)
3 J-6080-840-A Small Mirror Tape path adjustment
4 J-6087-000-A Upper Drum Eccentricity Adjustment Tool(5) Upper drum eccentricity adjustment
5 J-6152-450-A Wire Clearance Gauge Set Clearance check
6 J-6321-500-A Tape Guide Adjustment Driver Tape guide height adjustment
7 J-6323-530-A Stop Washer Fastening Tool Installation of stop washer
8 J-6323-890-A FWD Back Tension Measuring Cassette FWD back tension adjustment
9 J-6325-110-A Torque Screwdriver’s Bit(for M1.4) Tightening screws
J-6325-380-A Torque Screwdriver’s Bit(for M2)
10 J-6325-400-A Torque Screwdriver(for 3 kg)
11 J-6325-530-A Upper Drum Eccentricity Adjustment Tool(6) Upper drum eccentricity adjustment
12 J-6326-120-A Hexagon Bit Tightening screws
13 J-6421-330-A Extension Board, BC-133 DIF-31 board check
14 J-6421-430-A Extension Harness, VIDEO Board check
15 J-6421-440-A Extension Harness, AUDIO
16 J-7031-460-A Torque Screwdriver’s Hexagonal Bit Tightening screws
(across 1.27)
17 2-034-697-00 Cleaning Piece Cleaning
18 7-661-018-18 Mitsubishi Diamond Machine oil Hydro Fluid Lubricating
NT-68 (50 ml bottle)
19 7-700-736-05 L-shaped Hexagonal Wrench (d=1.5 mm) Removal of screw
20 8-960-073-01 Alignment Tape,ZR5-1 Digital video and audio adjustment
(for NTSC)
8-960-073-11 Alignment Tape,ZR2-1 Tracking adjustment(for NTSC)
8-960-073-51 Alignment Tape,ZR5-1P Digital video and audio adjustments
(for PAL)
8-960-073-61 Alignment Tape,ZR2-1P Tracking adjustment(for PAL)
21 9-911-053-00 Thickness Gauge Clearance check
22 9-919-573-01 Cleaning Fluid Cleaning
Standard Products Cleaning Tape,BCT-D12CL or BCT-5CLN Cleaning
Blank Tape,BCT-D40 Electrical adjustment
Blank Tape,BCT-D124L Tape path adjustment
The following fixtures are used for only Maintenance Manual Part2 Vol-1.
Fig. No. Part No. Description For use
23 J-6031-840-B Multi Connector Cable (CIBNC) Video system adjustment
24 J-6086-570-A Reference Flat Plate Audio/TC head zenith adjustment
25 J-6322-420-A Tape Guide Adjustment Driver (45) Tape path adjustment
J-6322-420-3 TG Driver Spare Bit (across 0.89) (for spare)
1-14. Optional Accessories