2-1
DVW-250/250P
2-1. Error Message
This unit features self-diagnostics.
When trouble is detected, an error code and error message are displayed
immediately in the audio meter LCD on the front panel.
Section 2
Error Messages
Code
Error message
ERROR-01
REEL TROUBLE-1
Audio Meter LCD
Code Error message Description
01 REEL TROUBLE 1 The slack of the tape is detected during threading or unthreading
02 REEL TROUBLE 2 The slack or breaking of the tape is detected in search, fast forward, or rewind
mode.
03 REEL TROUBLE 3 The slack or breaking of the tape is detected in playback or recording mode, or
either of the lock of the supply or take-up reel is detected.
04 REEL TROUBLE 4 It is detected that the tape does not run at the speed of designation in fast
forward or rewind mode.
05 REEL TROUBLE 5 It is detected that the supply or take-up reel cannot stop with a cassette is not
inside, or detected thatover current has been flowing to supply and take-up
reels.
06 TAPE TENSION ERROR Excessive tension is detected.
07 CAPSTAN TROUBLE It is detected that the tape does not run at the speed of designation in search or
playback mode.
08 DRUM TROUBLE It is detected that drum motor rotation is not normal.
09 THREAD MOTOR TIME OUT It is detected that threading or unthreading is not completed within the pre-
scribed time.
0A THREADING TROUBLE It is detected that threading cannot be done.
10 HUMID Condensation is detected.
11 TAPE TOP/END SENSOR TROUBLE Tape top and end are detected at the same time.
12 TAPE TOP SENSOR TROUBLE The tape top sensor operation is defective.
13 TAPE END SENSOR TROUBLE The tape end sensor operation is defective.
20 CASSETTE COMPARTMENT MOTOR LOCK It is detected that cassette up/down operation is not completed within the
prescribed time.
92 INTERNAL INTERFACE ERROR The interface between SY(IC15/SST-3 board) and SV(IC404/SST-3 board) is
defective.
93 CPU INITIALIZE ERROR Abnormal conditions are encountered during system initialize after the POWER
sub error message switch is turned ON.
SY SY:IC15/SST-3 board
SV SV:IC404/SST-3 board
96 RAM TROUBLE The checksum error arise in the RAM with battery backup for system control.
IC28/SST-3 board
97 SV NV-RAM TROUBLE The checksum error arise in the NV-RAM for servo.
IC405/SST-3 board
99 INTERFACE ERROR The interface between SY(IC15/SST-3 board) and PROC(IC305/DPR-62 board)
is defective.
To Next Page
