5-5
DVW-250/250P
5-1-5. Cleaning of Tape Running System and Tape Cleaner
Notes
Tape cleaner has a sharp edge. Never touch the edge by bare hands. Take care to clean.
Tools
• Cleaning cloth :3-184-527-01
• Cleaning fluid :9-919-573-01
Procedures
1. Clean the tape running surfaces (shaded portions) of the following guides and the edge portion of the
tape cleaner using a cleaning cloth moistened with cleaning fluid as shown in the figure.
S1 guide, S2 guide, S3 guide, S4 guide, S5 (tension regulator) guide, T1 guide, T2 guide, T3 guide,
T4 guide, capstan and pinch roller
CAUTION
Never touch the edge portion of the tape cleaner by bare hands. It is danger of cutting your finger
because the tape cleaner has a sharp edge.
2. Clean the gap of the tape cleaner that cloggs with the magnetic powder using a paper (or equivalent).
3. After cleaning, be sure to clean the tape running surfaces of the above guides and the edge portion of
the tape cleaner using a dry cleaning cloth.
5-1. Cleaning
Pinch roller
T3(T-drawing)
tape guide
T2 tape guide
T1 tape guide
Capstan
S5 (Tension Regulator)
tape guide
Tape cleaner
S3 tape guide
S1 tape guide
S2 tape guide
S4(S-drawing)
tape guide
T4 tape guide
To Next Page
