Sony DVW-250 - Page 44

3-2
DVW-250/250P
Audio Meter LCD Discription
VIDEO 1 (for NTSC only)
<SETUP LEVEL>
<YC SEP MODE>
<BLANK LINE>
CAMERA ............. Select input signal from camera.
ANA : Y/R-Y/B-Y signal
DIGI : digital signal
AUTO : Select automatically, depending on whether camera is outputting a ANA/DIGI identifying signal.
STD/NSTD ............. Select standard/nonstandard composite input signal.
AUTO: Select automatically, depending on whether luminance and chrominance signals are
interleaved.
STD : Always use standard signal.
NSTD: Always use nonstandard signal.
It the color frameing of the input video signal is unstable, select NSTD.
EXIT
SETUP LEVEL
MASTER LEVEL ............. Master level
0.0 % to 10.0 % in 0.5 % steps
INPUT LEVEL ............. Setup level of input signal
0.0 % to 10.0 % in 0.5 % steps
MST : same value as master level
V BLANK RM ............. Setup elimination in vertical blanking interval
OFF : no setup elimination
ON : Carry out setup elimination.
OUTPUT LEVEL ............. Setup level of output signal
0.0 % to 10.0 % in 0.5 % steps
MST : same value as master level
EXIT
YC SEP MODE ............. Toggle Y/C separation for each line.
LINE 12 to 20 (for NTSC) BPF : Carry out Y/C separation.
LINE 9 to 22 (for PAL) B/W : no Y/C separation; treat as Y signal
EXIT
BLANK LINE ............. Toggle blanking for each input line.
LINE 12 to 20 (for NTSC) THRU: no blanking
LINE 9 to 22 (for PAL) BLNK : blank input line
VIDEO 2
FREEZE ............. Select freeze mode.
FLD : Freeze single field.
FRM : Freeze frame
VIDEO LVL ............. Set the video output level.
-3 dB to +3dB in 0.1dB steps
<SYSTEM PHS>
EE DELAY ............. Select the sync phase in E-E mode.
SYNC: Output in phase with playback.
VID : in phase with E-E signal
VIDEO DATA ............. Set the word length for digital video output signals.
8 or 10 bits
SDI OUT ............. Toggle serial digital output on and off.
ON : output
OFF : no output
V PROC ............. Select whether or not video signal accords to CF information.
OFF : According to CF
ON : no according to CF (no H shift)
EXIT
3-1. Setup Menu