6-3
DVW-250/250P
2. Unthreading end mode
Unthreading end mode means that the S and T sliders move from the catchers S and
T to the directions of the reel tables, and then stop. This mode is the same as the
eject completion mode.
(1) To enter the unthreading end mode
• Press the EJECT button.
(2) To enter the unthreading end mode manually
• Turn the power off.
• While keep pushing the brake release lever toward you, and turn the manual
eject gear counterclockwise as far as it will go while pushing it downward.
• Turn the red gear on the left of the cassette compartment toward the battery
case and put the cassette compartment into the up state.
n
When no cassette is in the cassette compartment, do not turn the red gear.
6-1. General Information for Mechanical Part Replacement
To Next Page
