112
File Operations
Chapter 5 Storage and Retrieval of User Setting Data
If a video level in the range of 560 to 630 mV cannot
be obtained, do not adjust the ND offsets.
6
Attach the ND filter to be used as the reference for
white balance adjustment and select ND: 1.
7
Adjust the iris of the lens so that the video level you
wrote down in step 5 is obtained.
8
Perform the auto white balance adjustment.
9
Replace the ND filter, change to ND: 2, and repeat
steps 7 and 8.
10
Replace the ND filter, change to ND: 3 and repeat
steps 7 and 8.
11
Replace the ND filter, change to ND: 4 and repeat
steps 7 and 8.
12
Replace the ND filter, change to ND: 5 and repeat
steps 7 and 8.
13
Store the ND offset values in the OHB file, by
executing STORE FILE on the <OHB FILE> page of
the FILE menu.
Be sure to accurately adjust to the video level you noted in
step 5. If the level is not obtained through the iris
adjustment of the lens, use the shutter function or the
master gain adjustment.
To use the ND offset values
An appropriate offset value is automatically retrieved
when you change the ND filter setting.
To initialize the ND offset values
Perform ND OFFSET on the <OHB FILE> page (subpage
of the <FILE PRESET 2> page of the FILE menu).
5-3-9 Resetting to the Initial
Settings
With the <FILE PRESET 1> and <FILE PRESET 2>
pages of the FILE menu, data in the modified files or the
configuration of the edited USER menu can be reset to the
initial settings, by type of files or collectively.
<FILE PRESET 1> page
<FILE PRESET 2> page
To reset data of files by type of files
To reset data of the operator file, User-Gamma
file, User-MLUT file, and reference file
Position the pointer to the corresponding line then push on
the MENU SEL/ENTER dial.
The data in the corresponding file in built-in memory will
be reset to the initial settings.
The configuration of the USER menu can be reset in the
same manner.
To reset data of the lens files
• To reset data of all lens files, position the pointer to
LENS FILE (ALL) and push on the MENU SEL/
ENTER dial.
• To reset data of a specific lens file, assign the file number
in the No. column and push on the MENU SEL/ENTER
dial to position the pointer to the CLEAR column. Then
push on the MENU SEL/ENTER dial again.
To reset the data of the OHB file
In a case of the OHB file, resetting can be performed by
item.
Position the pointer to OHB FILE then push on the MENU
SEL/ENTER dial. The <OHB FILE PRESET> page will
be displayed.
Note
Note
<FILE PRESET 1> F07 TOP
c
OPERATOR FILE
USER MENU
M.S. FORMAT
<FILE PRESET 2> F08 TOP
c
USER GAMMA FILE
USER MLUT FILE
LENS FILE(ALL)
No.: 1 CLEAR: EXEC
REFERENCE FILE
10 SEC CLEAR: OFF
OHB FILE
FILE PRESET (-OHB)
To Next Page
Loading...
