133
Warning/Error Messages
Appendixes
Warning/Error Messages
If battery power is low or a problem occurs at power on or
during operation, a warning is given by an indicator
flashing or various alarm indications.
1) Recording error messages:
When using an SRW-1 mounted on the F35 or connected to the F35 via an
optic cable, a message is displayed if abnormality is detected in recording
on the SRW-1. The RUN indicator and tally lamp of the camera and the red
tally of the viewfinder flash quickly. Displayed message may vary
depending on the contents of error. While the alarm indication is activated
only during recording, it cannot be cleared until you turn off power.
Viewfinder screen Subdisplay RUN
indicator
Meaning
Basic status
display (page 50)
Message
BATT 12 V flashing BATT 12 V flashing Flashing Voltage of the 12 V power becomes low,
reaching the specified NEAR END value.
BATT 12 V quick
flashing
BATT 12 V quick
flashing
Quick
flashing
Voltage of the 12 V power becomes too
low, reaching the specified END value.
BATT 24 V flashing BATT 24 V flashing Flashing Voltage of the 24 V power becomes low,
reaching the specified NEAR END value.
BATT 24 V quick
flashing
BATT 24 V quick
flashing
Quick
flashing
Voltage of the 24 V power becomes too
low, reaching the specified END value.
TEMPERATURE CARE Temperature inside the camera raises.
TEMP WARNING/FAN
MAX
Temperature inside the camera raises to
the limit. FAN MODE is forcibly set to MAX.
SHUTDOWN CAMERA/
FAN MAX
The camera must be turned off for safety.
FAN MODE is forcibly set to MAX.
OHB/SIDE FAN NG! The fan near the CCD or the fan near the
side panel stops.
PS FAN NG! The fan near the power unit stops.
CAM? OHB NG! Abnormality of the CCD unit
CAM? AD BOARD NG! Abnormality of the AD board
CAM? DPR BOARD NG! Abnormality of the DPR board
CAM? VDA BOARD NG! Abnormality of the VDA board
CAM? TR BOARD NG! Abnormality of the TR board
CAM? AT BOARD NG! Abnormality of the AT board
IF BOX NG! Abnormality of the interface box
OPT CA NG! Abnormality of the CA-F101
UNKNOWN RECORDER An unknown recorder is connected.
VTR ALARM Alarm occurs at the SRW-1.
VTR WARNING Warning occurs at the SRW-1.
LASER SHUTDOWN! The laser-module protection circuit has
been activated with the CA-F101 mounted.
For details, refer to the Operation Manual
of the CA-F101.
REC DPR BOARD NG!
1)
Abnormality of the DPR or TR board
REC VTR NO SDI
INPUT!
1)
NO SDI INPUT error from the VTR
received
REC VTR MISSING!
1)
Communication with VTR shut off
REC PB CRC ERROR!
1)
CRC error detected in the PB signal from a
VTR
REC PB GREY!
1)
Gray signal over the entire screen detected
in the PB signal from a VTR