Sony F35 - Page 126

126
About Metadata
Appendixes
2. Master Gain
3. VTR Warning
Sample No. 34 Master gain
Code Master gain
0–6 dB
1–3 dB
20 dB
33 dB
46 dB
59 dB
612 dB
715 dB
818 dB
Sample No. 53 and 54 VTR Warning
Code VTR message Meaning
0001 PB FREQ MISMATCH System frequency of this system does not match system
frequency on the tape.
0004 NO PB LTC Playback LTC cannot be detected.
0005 NO PB VITC Playback VITC cannot be detected.
0007 REC INHIBIT MODE The system cannot record because of a record inhibit menu
setting. Or the tape is not formatted for recording.
0008 INVALID FMT CONV Format conversion is not possible with the current settings.
0009 TEMPERATURE LOW The temperature inside the unit is lower than the specified value.
000C DC VOLTAGE LOW DC voltage has fallen below the specified level.
000E TEMPERATURE HIGH The temperature inside the unit has risen.
000F VA MISSING SRPC-1 is not connected.
0010 TELEFILE FULL Telefile memory is almost full. The next recording will erase
existing data, beginning with oldest.
0011 TELEFILE NO ROOM Free memory in a Telefile has been completely exhausted.
0013 TELEFILE FMT NG Telefile format is invalid in 1 or more locations.
0014 TELEFILE RD FAIL Telefile read failure occurred.
0015 TELEFILE WR FAIL Telefile write failure occurred.
0016 TELEFILE WR INHI Attempt to record was made when entire Telefile is write inhibited.
0017 NO TELEFILE LABE Telefile could not be recognized.
0022 AUDIO PLL UNLOCK Audio clock generator PLL is not locked to reference video signal.
0030 NO SDI INPUT When the optional HKSR-101 is installed, there is no valid input to
the selected VIDEO I/O connector.
0032 INVALID SDI DATA SDI input signal data are invalid.
0034 SDI A-B PHASE NG Signals input to HD SDI IN A and B connectors are out of phase.
0036 SDI FMT MISMATCH Format of signals input to HD SDI IN A and B connectors does not
match system setting.
0037 SDI I/P MISMATCH I/P of signals input to HD SDI IN A and B connectors do not match
system setting.
004F AUDIO DSP UNLOCK Audio signal processing circuitry is not operating.
0050 NO PB RF Playback head is not reading digital data from tape.
0051 BAD CH CONDITION Playback signal quality is bad.