Sony HCD-BX2 - Setting the Clock Time

5
This section is extracted from
instruction manual.
1 Press CLOCK/TIMER SET.
The hour indication flashes.
.
nN Xx
mM
>
Step 2: Setting the
time
You must set the time before using the timer
functions.
The clock uses a 24-hour system on the
European model, and a 12-hour system on
other models.
The 12-hour system is used for illustration
purposes.
1
3,5
2,4
2 Press . or > repeatedly to set
the hour.
3 Press ENTER.
The minute indication flashes.
4 Press . or > repeatedly to set
the minute.
5 Press ENTER.
The clock starts working.
Tip
If you make a mistake, start over from step 1.
To change the time
The previous explanation shows how to set
the time while the power is off. To change the
time while the power is on, do the following:
1 Press CLOCK/TIMER SET.
2 Press . or > repeatedly to select SET
CLOCK.
3 Press ENTER.
4 Perform steps 2 through 5 above.
Note
The clock settings are canceled when you disconnect
the power cord or if a power failure occurs.