28
b Note
• Do not remove the eyecup pre-attached to the
camcorder.
Press the VF/LCD PANEL button.
The display changes with each press of the
button.
• To use only the LCD screen, press the
button until “VF/LCD PANEL: LCD
PANEL” is displayed on the LCD screen.
In this mode, appears on the LCD
screen.
• To switch between the LCD screen and
the viewfinder automatically, press the
button until “VF/LCD PANEL: AUTO” is
displayed on the LCD screen.
When AUTO is selected, the display
switches to viewfinder display
automatically whenever your eye is near
the eye sensor on the side of the
viewfinder. When you move your eye
away from the viewfinder, the display
switches back to the LCD screen.
z Tip
• The eye sensor will be activated if the eye
sensor is blocked, even if you are not looking
into the viewfinder.
Switching between LCD screen
display and viewfinder display
Large eyecup
(supplied)
Step 6: Adjusting the LCD screen and viewfinder (Continued)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
