42
KDL-26S3000/32S3000/40S3000/46S3000
KDL-26S3000/32S3000/40S3000/46S3000
KDL-32S3000 ONLY
1. Wire Dress Right Speaker wires and H4
cables in side clamp (white) and G3-Bd
bracket clip (black).
NOTE: H4-Bd/Rt. Speaker cables are dressed
UNDER AC Inlet.
2. Dress AC Inlet cables as shown.
Make sure Green/Yellow Earth Gnd. Is screwed
into lower LCD Bracket (w/4x8mm screw)
OPERATION PROCESS
NOTE: H4-Bd/Right Speaker cables
DRESSED INSIDE in plastic clip.
CLIP NOT ELIMNATED!!
2
1
CAUTION: DO NOT Push hard on AC
inlet wires after routing inside G1 bracket!!
Wire Insulation can be CUT by plastic edges!
NOTE Angle of Earth Gnd. Wire.
(Ring terminal touches "dimple" on plate)
NOTE BOTH H4-Bd and Rt. Speaker cables
are dressed UNDER AC Inlet and in G-Brkt
clamp with AC Inlet Wires.
NOTE Wires NOT dressed in small clip on
G1-Bracket. (Too difficult to dress with
gloves over hands)
H4 BOARD AND RIGHT SPEAKER (CONTINUED)
To Next Page
Loading...
Need help?
General