4
Operating Instructions
Connecting Additional Equipment
TV and VCR
1 Connect the coaxial cable from your TV antenna or cable service to
the IN jack on your VCR.
2 Connect a coaxial cable (not supplied) from the OUT jack on your
VCR to the VHF/UHF jack on the TV.
(Optional connection)
3 If your VCR is equipped with video outputs, you can get better
picture quality by connecting A/V cables (not supplied) from
AUDIO and VIDEO OUT on your VCR to AUDIO/VIDEO IN on
your TV.
✍ To watch video programs from your VCR, tune your TV to channel 3 or 4 (as
set on the rear of your VCR).
✍ You can use the button to switch between the VHF/UHF and VIDEO
inputs.
(Optional connection)
From
cable/
VCR
2
3
antenna
Rear of TV
1
Coaxial
Cable
To Next Page
Loading...
