Sony PRS-950 - Page 123

Changing Settings
123
Table of Contents Index
[Device Lock]
Locks the Reader by setting a pass code.
Tap [On] to set a pass code.
Input a 4-digit number by tapping the numeric key
pad.
Tap [OK] to lock the Reader.
To unlock, input the pass code and tap [OK]. Then tap
[Off] to unlock the Reader, and tap [OK].
Notes
ˎ
[0000] is the factory setting.
ˎ
You are recommended to make a note of your password
and keep it in a safe place separate from the Reader.
ˎ
If you forget your password, contact your Sony Customer
Support (
r
18); however, note that in unlocking your
device, all content on it will be erased.
ˎ
When the [Device Lock] setting is activated, the Reader will
not be recognized by your computer, please set to [Off]
before connecting.
[Standby Screen]
Sets the standby screen during the sleep mode. [Off]
displays nothing in the sleep mode.
ˎ
[Show picture]: Set [On] to show the selected
pictures on the standby screen. For details on setting
the pictures, see “To set as a standby screen” (
r
84).
ˎ
[Show message]: Set [On] to show messages on the
standby screen.