Sony SLV-D360P - Page 77

5-25-1
5. SCHEMATIC DIAGRAMS
SLV-D360P/D560P
◆ Block Identification of Main PCB - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-3
VCR Main PCB
5-1 S.M.P.S. - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-5
5-2 Power Drive - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-7
5-3 Logic/Function-Time - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-9
5-4 A/V - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-11
5-5 Hi-Fi/MTS - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-13
5-6 Input-Output- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-15
DVD Main PCB
5-7 DVD A/V Decoder - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-17
5-8 DVD Sub - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-19
Note
For schematic Diagram - Resistors are in ohms, 1/8W unless otherwise noted.
Special note : Most semiconductor devices are electrostatically sensitive and therefore require the special handling techniques described under the “electrostatically sensitive (ES) devices” section of this service manual. Important safety notices : Components identified with the mark
0
have the special characteristics for safety. When replacing any of these components.
Use only the same type.