MULTI CHANNEL AV RECEIVER
STR-DN1050/STR-DN850
Setting the speakers for zone 2 (for STR-DN1050 only)
When the speakers in zone 2 are connected to the SPEAKERS SURROUND BACK/BI-AMP/FRONT HIGH/FRONT
B/ZONE 2 terminals of the receiver, configure the settings so that the sound selected in zone 2 is output from the
speakers connected to the SPEAKERS SURROUND BACK/BI-AMP/FRONT HIGH/FRONT B/ZONE 2 terminals.
1. Select [Settings] - [Speaker Settings] from the home menu.
2. Select [Speaker Connection].
3. Set a speaker pattern without surround back and front high speakers.
4. Select [SB Speaker Assign] - [Zone2].
Note
If a speaker pattern with surround back speakers or front high speakers is set, you cannot set the SPEAKERS
SURROUND BACK/BI-AMP/FRONT HIGH/FRONT B/ZONE 2 terminals for a bi-amplifier connection or a zone 2
connection.
Notes on use
4-488-938-11(1)
Copyright 2014 Sony Corporation
Help Guide
To Next Page
Loading...
