Sony Trimaster EL BVM-E250 - Page 67

67
Function Setting Menu
Chapter 3 Menu
Function Switch
Marker Sets whether or not to display all markers ([Off] or On).
Notes
• The marker is not displayed in the following cases:
– When the input signal has no sync signal
– When the internal signal is displayed
– When the HDMI/DisplayPort computer signal is input
– When H Delay/V Delay is set to On
– When Side by Side, Wipe, Butterfly or Blending is set to On
– When Pixel Zoom is set to on
• The marker may be displayed in an incorrect position when External Sync is On.
Aspect Marker Sets whether or not to display the aspect marker ([Off] or On).
Notes
• The aspect marker is not displayed in the following cases:
– When the input signal has no sync signal
– When the internal signal is displayed
– When the HDMI/DisplayPort computer signal is input
– When H Delay/V Delay is set to On
– When Side by Side, Wipe, Butterfly or Blending is set to On
– When Pixel Zoom is set to on
• The aspect marker may be displayed in an incorrect position when External Sync is On.
Area Marker 1 Sets whether or not to display the area marker 1 ([Off] or On).
Notes
• The area marker 1 is not displayed in the following cases:
– When the input signal has no sync signal
– When the internal signal is displayed
– When the HDMI/DisplayPort computer signal is input
– When H Delay/V Delay is set to On
– When Side by Side, Wipe, Butterfly or Blending is set to On
– When Pixel Zoom is set to on
• The area marker 1 may be displayed in an incorrect position when External Sync is On.
Area Marker 2 Sets whether or not to display the area marker 2 ([Off] or On).
Notes
• The area marker 2 is not displayed in the following cases:
– When the input signal has no sync signal
– When the internal signal is displayed
– When the HDMI/DisplayPort computer signal is input
– When H Delay/V Delay is set to On
– When Side by Side, Wipe, Butterfly or Blending is set to On
– When Pixel Zoom is set to on
• The area marker 2 may be displayed in an incorrect position when External Sync is On.
Center Marker Sets whether or not to display the center marker ([Off] or On).
Notes
• The center marker is not displayed in the following cases:
– When the input signal has no sync signal
– When the internal signal is displayed
– When the HDMI/DisplayPort computer signal is input
– When H Delay/V Delay is set to On
– When Side by Side, Wipe, Butterfly or Blending is set to On
– When Pixel Zoom is set to on
• The center marker may be displayed in an incorrect position when External Sync is On.
Menu Function and operation ([ ]: factory setting)