76
System Configuration Menu
Chapter 3 Menu
Screen Saver Sets the screen saver function.
[On]: When a still image is displayed on the screen for 10 minutes or more, the
brightness of the screen is automatically reduced to prevent burn-in of the screen. The
brightness returns to normal if you input a moving image or operate the controller.
Approximately one minute before the screen saver is activated, the ECO lamp starts
flashing rapidly. Then the flashing slows in green when the screen saver is activated.
Off: Disables the screen saver function.
Note
The screen saver function is automatically set to On during manual adjustment of the color
temperature, contrast, brightness, chroma, and phase, regardless of the setting of this item.
Monitor Upgrade Upgrades the monitor.
When the item is selected, the screen for inputting the password is displayed.
After the 4-digit password is entered, the current versions of Software Version, Kernel
Version, FPGA Version, and DisplayPort Version are displayed.
For the FPGA Version, FPGA1 , FPGA2 and FPGA CORE are displayed from left to right.
For the password, see Password (page 74) of the System Configuration menu.
For details on upgrading the monitor, see “Upgrading the Monitor and Controller” on page
101.
Software Upgrade Upgrades the software for the monitor.
Kernel Upgrade Upgrades the kernel of the monitor.
FPGA Upgrade Upgrades the FPGA data of the monitor.
DisplayPort Upgrade Upgrades the DisplayPort data of the monitor.
Maintenance The menu for the Sony service representative is displayed.
Menu Function and operation ([ ]: factory setting)
To Next Page
Loading...
