Connecting and Installing the TV (continued)
Cable Box Connections
Some pay cable TV systems use scrambled or
encoded signals that require a cable box to
view all channels.
Cable box
1 Connect the coaxial connector from your
cable to the IN on your cable box.
2 Using a coaxial cable, connect OUT on
your cable box to VHF/UHF on your TV.
b
If you will be controlling all channel selection
through your cable box, you should consider using
the CHANNEL FIX feature discussed on page 26.
(Rear of TV)
Cable VHF/UHF
IN _-_OUT
Cable box
Cable box and cable
• KV-32S65, 32V65, 35S65, 35V65 only
For this set up, you can switch between
scrambled channels (through your cable box),
and normal (CATV) channels by pressing
ANT on your remote control.
Notes
• Your Sony remote control can be
programmed to operate your cable box.
(see page 32)
• When using PIP, you cannot view the
AUX input in the window picture.
lip "4"
PressingANT switches between these inputs,
If you are connecting a cable box through the AUX input and would [
like to switch between the A UX and normal (CATV) input you should
consider using the CHANNEL FIX feature discussed on page 26.
Cab{e I_.x (Rear of TV)
_ AUX
channels..._ ]_C_=z]_:_ TO-CONvERTER
75-ohm coaxial ,_(signal)
cable (not supplied) VHF/UHF
CATVcable
(unscrambted channets)
To Next Page
Loading...
