Sony Trinitron KV-35V35 - Operating a Cable Box or DBS Receiver

Operating a cable
box or DBS receiver
You can program the supplied remote commander to
operate a cable box or DBS receiver. Follow the
procedures below to set the manufacturer's code
number in the remote commander.
DBS/CABLE (POWER)
DBS/CABLE
(FUNCTION)
DISPLAY*
0 - 9 buttons
JUMP
TV/DBS*
ENTER
GUIDE*
altlelo! :
MENU*
CH +/-
CODE SET
* The TV/DBS, GUIDE, DISPLAY, 4/¥/+/*/ G5), and MENU
buttons can be used only with a DBS receiver.
1 Turn off the equipment you want to set up,
and press DBS/CABLE (FUNCTION).
-—-— FUNCTION ———
DBS/CABLE
2 Press the CODE SET, DBS/CABLE (FUNCTION),
and 0 ~ 9 buttons to enter the
manufacturer's code number (see the
chart), then press ENTER. For example, to
program your remote commander to
operate a Sony DBS receiver, press CODE
SET, DBS/CABLE (FUNCTION), 8, 0, 1, and
ENTER.
——— FUNCTION ——
CODE SET OBS/CABLE ENTER
BBR
RES
36 | Operations
3 Press DBS/CABLE (POWER) to turn on the
cable box or DBS receiver.
POWER
DBS/CABLE
4 Use the cable box/DBS control buttons to
check if the code number works.
For example, to operate a cable box or DBS receiver,
you can use the DBS/CABLE (POWER), JUMP, CH
+/-,0-9 and ENTER buttons.
Note
¢ If the cable box or DBS receiver does not have a certain
function, the corresponding button on this remote commander
will not operate.
To operate the TV
Press TV (FUNCTION). Then use the TV control
buttons to control the TV.
For more details on operating the cable box or
DBS receiver
Refer to the operating instructions that come with the
equipment.
If the remote commander doesn’t work
¢ First, try repeating the setup procedures using the other codes
listed for your equipment.
Manufacturer code numbers (cable box)
Manufacturer Code number
222, 223, 224, 225, 226
Hamlin/Regal
Jerrold/G. I. 201, 202, 203, 204, 205, 206, 207, 208,
218
Oak 227, 228, 229
Panasonic 219, 220, 221
Pioneer 214, 215
Scientific Atlanta 209, 210, 211
Tocom 216, 217
Zenith 212, 213
Manufacturer code numbers (DBS receiver)
Manufacturer Code number
Sony 801 (preset code for the supplied
remote commander)
RCA 802
Notes
* If more than one code number is listed, try entering them one
by one until you come to the correct code for your equipment.
¢ If you enter a new code number, the code number you
previously entered at that setting is erased.
* In some rare cases, your equipment may use a code that is not
provided with this remote commander and you may not be
able to operate your equipment with the supplied remote
commander. In this case, use the equipment’s own remote
control unit.
¢ Whenever you remove the batteries — to replace them, for
example — if too much time is taken, the code numbers may
revert to the factory setting and must be reset.