SoundCraft Si Series User Manual

Page 5 - 4 Soundcraft® Si Series User Guide
OUTPUT BAY
The output channels’ SOLO buttons are used to solo the selected channel. The output Solo is always AFL.
The output Solo is mono unless output busses have been stereo linked in which case the Solo is stereo.
The activated SOLO button will illuminate Blue.
Note: The L, R & C busses cannot be soloed. Individual VCA’s cannot be soloed if no inputs have been as-
signed to them.
Highlighted AFL
If several outputs are soloed and then one of them is pressed and held, the others will be dimmed by 20dB
(the default value, this can be adjusted via the SOLO touchscreen) and will be illuminated pink. Release the
held solo to revert to standard AFL mode.
Solo Trim
This allows the user to adjust the overall level of the solo bus. The default is 0dB. Adjustment is via the Solo
page of the touchscreen (see Chapter 6).
Blend Level
When a SOLO button is pressed, the soloed signal is routed to the monitor system, at the same time the
monitor system’s other signal sources are reduced to the level set by this parameter. The default is minus
innity. Adjustment is via the Solo page of the touchscreen (see Chapter 6).

SoundCraft Si Series Specifications

General

Model Variants	Si Expression, Si Performer, Si Compact, Si Impact
Built-in Effects	Lexicon effects engine
Type	Digital mixer
EQ Bands	4-band EQ per channel
Subgroups	4 subgroups
Effects Engines	Lexicon effects engine
Faders	Motorized faders
Display	Varies by model
Dimensions	Varies by model
Weight	Varies by model