SoundCraft Si Series User Manual

Page 6 - 7Soundcraft® Si Series User Guide
OSCILLATOR
Route to bus
If this is enabled the Oscillator signal will be routed to any Aux/Group bus which is Soloed whilst the Talkback
ON key is enabled.
Route to all buses
If this is enabled the Oscillator signal will be routed to all Aux/Group buses whilst the Talkback ON key is
enabled.
Level
Set the level of the oscillator signal.
Frequency
Set the frequency of the oscillator signal (Sine only).
Type
Sine or Pink Noise. NOTE: The OSC is always routed to the OSC OUT XLR on the rear connector panel.
EXTERNAL TALKBACK
Route to monitors
Enables the routing of the External Talkback signal from the External Talkback Line Input XLR on the rear-con
to the monitors.
Route to headphones
Enables the routing of the External Talkback signal from the External Talkback Line Input XLR on the rear-con
to the headphones.
Level
Adjusts the gain of the External Talkback input.

SoundCraft Si Series Specifications

General

Model Variants	Si Expression, Si Performer, Si Compact, Si Impact
Built-in Effects	Lexicon effects engine
Type	Digital mixer
EQ Bands	4-band EQ per channel
Subgroups	4 subgroups
Effects Engines	Lexicon effects engine
Faders	Motorized faders
Display	Varies by model
Dimensions	Varies by model
Weight	Varies by model