Q
(.)
Symptom
Power does not turn
on.
Cause
Remedy
Fuse is blown
(No sound is
produced.)
Replace with fuse
of
the same amperage.
If the fuse blows again, consult your store
of
purchase
r---------------~~----------------------------
No sound output
when operating the
unit with amplifiers
or power antenna
attached.
In
correct wiring
Power antenna!
lead is shorted to
ground excessive
current is required
or remote
on
the
amplifiers or power
antenna.
Nothing happens
when buttons
pressed.
The microprocessor
are has malfunctioned
Display is not
Accurate
due to noise, etc.
Panel or main unit
Connectors
are dirty
Compact disc is
Consult your local retailer.
1.
Turn off the unit.
2.
Remove all wires attached to the
power antenna lead. Check each wire
for a possible short to ground using an
ohm meter.
3.
Turn on the unit.
4. Reconnect each amplifier remote wire
to the power antenna lead one by one.
If the amplifiers turn off before all wires
are attached, use an external replay to
provide remote-on voltage (excessive
current required).
Turn off the power, Then press the [no
open] button and remove the DCP. Press
the reset button for about 2 seconds with
a thin rod.
Wipe the dirt off with a soft cloth
moistened with cleaning alcohol.
Clean the compact disc without scratches
Sound is bad directly dirty
~~------------~----------------------------~
after power is turned Compact disc is
on. heavily scratched
Sound is bad directly
after power
is
turned
on.
or warped
Water droplets may
form on the internal
lens when the car is
parked
in
a humid
place
When deck
Replace with a compact disc without
scratches.
Let it dry for about 1 hour with the power
on.
mechanism error, it Reset the unit.
show ERROR 1
When disc or servo
3 Small LCD display
..J error massage
error, it show Change the disc or reset the unit.
ERROR2
When USB error, it 1.Remove the USB/SO and insert it again
show ERROR 3
1---W--h_e_n_S_D
__
e_rr-o-r,-i-t
___,
2.
File error, please check the file.
show ERROR
4
3.
Reset the unit.
17
To Next Page
Loading...
