Spaceman 6224 - Page 29

Page26
Section8 Troubleshooting Guide
PROBLEM
PROBABLE CAUSE
REMEDY
PAGE
REF.
5.
The freezing
cylinder walls
are scored.
a. Operating freezer
without the front bearing
on the freezer door.
b. The gear unit or the
direct drive is out of
alignment.
a. Install the front bearing
on the freezer door.
b. Contact service
technician.
10
6.
Excessive
leakage in
rear drip pan.
a. A worn or defective
O-ring are on the beater
drive shaft.
b. The rear shell bearing is
worn.
c. Incorrect lubricant was
used.
d. Inadequate lubricant of
beater drive shaft.
a. Replace the O-rings
every 3 months.
b. Contact service
technician.
c. Use food lubricant.
d. Lubricate the beater
drive shaft properly.
10
7.
The draw
valve is
leaking.
a. Incorrect lubricant was
used.
b. A worn or defective
O-ring are on the draw
valve.
c. Inadequate lubricant of
draw valve.
a. Use food lubricant.
b. Replace the O-rings
every 3 months.
c. Lubricate the draw
valve shaft properly.
8.
Product is not
feeding into
the freezing
cylinder.
a. The mix level is
inadequate in the mix
hopper.
b. The mix inlet hole is
frozen.
a. Fill the mix hopper with
mix.
b. Contact service
technician.
13
9.
The unit goes
out on
overload
excessively.
a. There are too many
appliances plugged into
the circuit.
b. An extension cord has
been placed between the
power cord and the wall
receptacle.
a. A separate 30 Amp
circuit is needed for the
freezer to operate
properly.
b. If the extension cord is
used, it must match the
power cord in size of
circuit ampacity.
1
1