Spaceman 6224 - Page 28

Page 25
Section8 Troubleshooting Guide
PROBLEM
PROBABLE CAUSE
REMEDY
PAGE
REF.
1.
No product
being
dispensed
a) The mix level is
inadequate in the mix
hopper.
b) The beater motor
overload.
c) The unit is unplugged at
the wall receptacle.
d) The circuit breaker is
tripped or the fuse is
blown.
e) The freezer door is
incorrectly assembly.
f) Product is being drawn
off in excess of freezer’s
capacity.
a. Fill the mix hopper with
mix.
b. Reset the freezer.
c. Plug in the power cord.
Press the reset switch.
d. Place the circuit breaker
in the “ON” position, or
replace the fuse. Press
the reset switch.
e. See “Operating
Procedures” for proper
installation.
f. Stop drawing product
and allow the unit to
recover.
8
9
1
9
1
9
10
13
2.
The machine
will not
operate in the
“AUTO”
mode.
a. The unit is unplugged.
b. The circuit breaker is
tripped or the fuse is
blown.
c. The beater motor
overload, causing a loss
of power to the power
switch.
a. Plug in the power cord;
press the reset switch.
b. Place the circuit
breaker in the “ON”
position, or replace the
fuse. Press the reset
switch.
c. Reset the freezer.
1
1
9
9
3.
The product
is too hard
a. The product is set too
hard.
a. Adjust product softer.
17
4.
The product
is too soft
a. The product is set too
soft.
a. Adjust product harder.
17