INDEX Page. 6 of 92
WARNING!
DO NOT use an extension cord with the AC power cable unless it is correctly rated as
there will be a risk of fire or electric shock. And could compromise the operation of the
amplifier.
WARNING!
DO NOT allow metallic objects or wires to enter inside the amplifier.
WARNING!
DO NOT obstruct the cooling vents at both the sides, back and front of the amplifier.
Ensure that no objects impede the correct operation of the fans
WARNING!
DO NOT expose the linear amplifier to rain, snow or any liquids.
WARNING!
DO NOT install the linear amplifier in a place without good ventilation. This could limit heat
dissipation and the amplifier could be damaged.
WARNING!
DO NOT touch the amplifier with damp or wet hands.
This could cause an electric shock.
Avoid opening the amplifier before you have disconnected it from the mains supply plus
wait at least 2 minutes for the electrolytic capacitors to complete their discharge.
To clean the amplifier DO NOT use chemical agents like alcohol or benzene as the plastic
surfaces could be damaged.
AVOID using the amplifier in areas with temperatures below 0° C (+32°F) or above +40°C
(+104°F).
AVOID using the linear amplifier in locations that are very dusty, damp, have high humidity
or that are in direct sunlight.
AVOID placing the linear amplifier against walls where the circulation of the air would be
obstructed and the noise of the fans would be reflected toward the operator.
AVOID permitting children to play with the amplifier.
If you do not use the linear amplifier for a long time, set the back main switch [I/O] to the
OFF position [O].
To Next Page
Loading...
