INDEX Page. 5 of 92
HOW TO READ THIS MANUAL
This manual is divided into four main parts:
• First part, from chapter 1 to chapter 9.
The characteristics of the amplifier are described, it is essential to read this to fully
understand this amplifier’s potential capabilities that make this product unique.
• Second part, from chapter 10 to chapter 11.
Programming and startup of the amplifier is described step by step. Some advice is
also given on how to manage various transmission modes.
• Third part, from chapter 12 to chapter 16.
This section details how to interface the amplifier with other equipment.
How to build cables, using USB/RS232 ports for remote control, downloads, etc.
• Fourth part, chapter 20.
Provides all the information for software management.
PRECAUTIONS
Explicit definitions
Serious problems if not observed. Danger of fire or electric shock for the operator,
or damage to the equipment.
WARNING!
DO NOT disconnect any antenna from the amplifier during transmission.
This could cause a risk of electric shock RF burns or fire.
WARNING!
DO NOT modify the internal wiring of the amplifier. Any modifications will invalidate the
warranty, and may reduce the performance of the linear amplifier or damage it.
WARNING!
Before using the linear amplifier, compare the value of voltage of your local AC mains
supply system with those required by the amplifier.
WARNING!
DO NOT turn ON the linear amplifier unless it has been properly grounded through the
GND conductor of the AC mains cord.
Do not disconnect this ground under any circumstances, this may lead to a risk of severe
or fatal electric shock.
To Next Page
Loading...
