User’s manual EXPERT 1K-FA
Pag. 12 of 76
controls and verifies data coming from the transceiver. Automatic
management of bands, antennas and tuner can be done in the following way:
a) In all recent transceivers through CAT connection.
b) In the older ICOM models, through “BAND CONTROL VOLTAGE”.
c) In the YAESU models not listed, or without CAT, through "BAND
DATA".
d) In every other case through the internal frequency counter.
Note: in case d) the CAT link with the transceiver is not needed because the
frequency is detected from the transmitted signal.
Note: in some transceivers the “RELAY” and “CAT” signals are activated by
menu selection: refer in this case to their proper user’s manuals.
To Next Page
Loading...
