SPE EXPERT 1K-FA - SPE CAT Settings; ICOM CAT Settings

User’s manual EXPERT 1K-FA
Pag. 54 of 76
18.7 SPE CAT Settings
[
SET
]
Note: SPE CAT doesn’t need any baud-rate setting since it is internally fixed.
18.8 ICOM CAT Settings
Note: when CI-V setting is made, the transceiver must be enabled in its “TRANSCEIVE ON”
status following the proper setup sequence described in its reference manual.
Note: if the analog
VOLTAGE_BAND
inteface is chosen, the baud-rate setting will not be
shown as it is useless. In order to avoid troubles, this setting must be chosen only if the
transceiver is not equipped with any CI-V CAT interface.
[
SET
]
[
SET
]
[
SET
]
[
SET
]
[
SET
]
[
SET
]
[
SET
]