SPE EXPERT 1K-FA - Page 49

User’s manual EXPERT 1K-FA
Pag. 49 of 76
The
Selected input settings
are used for characterizing some parameters relative to
both the inputs and they are:
·
ANTENNA
for setting the proper antenna (up to a maximum of two) for every
ham band relative to the selected input.
·
CAT
for setting the proper
CAT
interface relative to the selected input.
· MANUAL TUNE for making some manual fine-tune operations inside the tuned
band relative to the selected input.
The
Global settings
perform their action over the whole system and they are:
· BACKLIGHT for setting the LCD backlight brightness.
·
CONTEST
for setting one of the two handling modes of the amplifier’s cooling
fans (CONTEST On/Off).
·
BEEP
for enabling/disabling the acoustical feedback following any keystroke
coming from the amplifier’s keyboard.
· START
for setting the amplifier’s startup mode (STANDBY/OPERATE) occurring
after the next power-up.
· TEMP.
for displaying the temperature measurements using either Celsius
degrees (°C) or Fahrenheit degrees (°F).