Spectra Precision Focus 30 User Manual

Spectra Precision FOCUS 30 User Guide 23
3 Getting Started
Touch Screen
The CU LCD screen in Face1 can be viewed easily both in direct sunlight and in over-
cast conditions. It also incorporates a touch interface for navigation. Tap elements on
the screen with a stylus or your finger.
Calibrating the Touch Screen
If the touch screen does not respond properly when you tap it, recalibrate it as fol-
lows:
1. Tap the Start menu and select Settings/Control Panel/Stylus. The Stylus
Properties appears.
2. To recalibrate, tap Recalibrate in the Calibration tab.
3. Follow the prompts on the screen.
Disabling the Touch Screen
To clean the touch screen during a survey, press T + B [S] to disable it. To enable
the touch screen again, press T + B.
Display Backlight Face1 Control Unit
The display light is active by default and can be toggled on/off by pressing T + A
[C]. To change backlight brightness and save battery life
1. Tap the Start menu and then select Settings/ Control Panel/ Display Properties/
Backlight.
2. Adjust Backlight brightness and select when the instrument has to turn off the
backlight automatically.
3. Tap OK.
Note – Settings for display light Face2 and reticle illumination see Settings Face2
Display Backlight, Reticle Illumination and Tracklight, page 42.
Settings Time and Date
1. Tap the Start menu and then select Settings/Control Panel/Date/Time.
2. Change the date and time as required.
3. To accept the new settings, tap OK. To cancel, tap B.
Note – when you attach the instrument to your computer using Microsoft
®
ActiveSync
®
technology, time and date are automatically updated.

Spectra Precision Focus 30 Specifications

General

Brand	Spectra Precision
Model	Focus 30
Category	Measuring Instruments
Language	English