Spectra Precision Trimble UL 633N - 8.4 Pairing the laser with the signal transporter (ST802;ST805); 8.5 Grade Entry; 8.6 Grade Display

18
A
B
C
Next,turnonthereceiverthenpressandholdtheDeadband(A)andtheAudio(B)buttonsfortwoseconds.
AftertwosecondsthedisplayshowsMENUrst,thenRDIO.
PressandreleasetheUnits(C)button–displayshowsthecurrentradiomode.
IfnotalreadysettoLS,pressUnitsbuttonandthenpressDeadbandorAudiobuttonuntilLS is displayed.
PressUnitsbuttonagaintoenterselection.PressandreleasetheAudiobutton–displayshowsPAIR.Press
theUnitsbuttonagain–thedisplayshowsPAIRandarotatingbar.AftercompletingPAIR,OKwillbedisplayed.
TheUL633Npairsnowautomaticallywiththenewreceiver.PressandreleasethePowerbuttontwotimesto
exitthemenu.Alasersymbolislittoconrmthereceivercancommunicatewiththelaser.
8.4 Pairing the laser with the signal transporter (ST802/ST805)
MakesuretheST802/ST805isswitchedoff.StartwiththeLaser.WheninmenuSettings(Pic59),pressand
releasebutton4toopenthepairingmenu(Pic71).Thedisplayshowsthecurrentlypairedunits(onesignal
transportermax).MakesuretheSTslotisfreeforthesignaltransportertobepaired.Iftheslotisnotfree,
choosetheSTslotanddeleteitusingbutton1(CLR).Pressbutton2tostartthepairingprocess.Switchon
thesignaltransporter.Thesignaltransporterpairsautomaticallywiththelaser.Ifthepairingwassuccessful
theaddressorIDofthepairedSTisshowninthepairinglist;alsothesignaltransportershowsasolidblinking
yellowstatusLED.
8.5 Grade Entry
SelecttheGradeEntryicon(Pic73)andpressandreleasebutton4toopentheGradeEntrymenu.
Buttons6/7canbeusedtotogglebetweenStepandGo(Pic74)andDigitSelect(Pic75).
Press and release button 4toconrmtheselection.
Pic 74
Step and Go
Pic 75
Digit Select
8.6 Grade Display
SelecttheGradeDisplayicon(Pic76)andpressandreleasebutton4toopentheGradeDisplay
menu.
ThedesiredGradeDisplayMode(Percent(Pic77)/Permille(Pic78)/Degree(Pic79))canbe
selected using the buttons 6/7. Press and release button 4toconrmtheselecteddisplaymode.
Pic73
GradeEntry
Pic76
GradeDisplay
Pic78
Per mill
Pic77
Percent
Pic79
Degree