SpectraPure
®
SpectraPure
®
Inc.
480.894.5437 Call us toll-free 1.800.685.2783
2167 East Fifth St, Tempe, Arizona 85281
24
Navigating the LM4:
After a ReStart, the blinking underline cursor should be in the upper left
corner of the display and indicates the “current pump”. The parameters for
that pump are available to change. Press the or button to select the
“current pump”you wish to adjust – A, B, C, or D.
Press the
button to select the “Settings” page. Press again to select
the “Calibrate” page, again to select the “System” page, and again to return
to the Settings page. Press the button at any time to step back through
this sequence of pages.
At any time, pressing the APO button will disable All Pumps. When all
pumps are off, only the button will re-enable the pumps. The other four
buttons will beep rapidly but not be responsive. Pumps may be calibrated
when All Pumps are Off.
A: Settings
Mode: OFF
Rate: 100 ml/m
SpectraPure
LiterMeter 4
ALL PUMPS OFF
If ALL PUMPS OFF is displayed:
NO PUMP CAN RUN FOR ANY REASON
(except during individual Calibrations)
If ALL PUMPS OFF (APO button
) is
pressed:
ALL PUMPS ARE ENABLED and Settings,
Calibrate, or System page is displayed -
whatever was displayed when power was
interrupted or APO was pressed.
If the APO button ) is pressed again,
the LM4 returns to ALL PUMPS OFF.
LiterMeter 4 Basic Operation:
The LM4 will return to the state it was in when a Restart occurs
or power is lost and restored. All Pump functions and timings will
be restored and operation will continue.
SpectraPure
LiterMeter 4
ALL PUMPS OFF
To Next Page
Loading...
