SpectraPure
®
SpectraPure
®
Inc.
480.894.5437 Call us toll-free 1.800.685.2783
2167 East Fifth St, Tempe, Arizona 85281
36
Toggled:
Now, LM4
will USE
WiFi Router.
Toggled:
Now, LM4
will NOT USE
WiFi Router.
The LM4 has an internal clock that is very accurate, day-to-day. The
Daily, Dose, and Once Modes use this clock. However, the TIMER and
DELAY Modes need to know the actual time They get the time from the
Internet, and that requires connecting to a local WiFi router. There may
be a situation where a local router is not available, or it is not desirable
to connect to a local network, or the TIMER or DELAY Mode will not be
used. In these cases you will not want to wait for the “Auto-Connect to
a Router at ReStart” to timeout after 6 minutes, every time it is restarted.
To skip searching for a router, hold the button down directly after a
ReStart. Hold the button down until you hear three beeps and you see:
Release the
button. This “toggles” the
Router Mode off. Future ReStarts will continue
without asking for a router or credentials
And, if you wait for the LM4 to completely
restart and do it again, you will toggle the
Router Mode back on. See “Normal Restart
Sequence”.
REMINDER: Even without an established router connection, you can
access the LM4 using a Personal Device on the LM4-XXXX
Private Network and URL = 192.168.4.1
Toggle the Use/No Use of a Router (LEFT Button )
:
To Next Page
Loading...
