SpectraPure
®
SpectraPure
®
Inc.
480.894.5437 Call us toll-free 1.800.685.2783
2167 East Fifth St, Tempe, Arizona 85281
35
Config Buttons Schedule
LEFT Button Toggle the Use/No Use of a Router
RIGHT Button Toggle Master/Remote Mode
APO Button Clear and Restore to Factory Settings
DOWN Button Not Used (yet)
UP Button Clear WiFi Parameters (SSID & password)
There are two ways to ReStart the LM4:
When the LM4 is already powered-up and operational, press and hold
BOTH LEFT ( ) and UP ( ) buttons AT THE SAME TIME. Continue
to hold the buttons down until the LM4 beeps two times. Release the
buttons and the LM4 will ReStart.
The LM4 can also be restarted by removing and then re-applying power
to the unit. Plug the power supply into an AC outlet, then connect the
12VDC power supply to the LM4 Power Input jack on the side of the
unit.
There are some functions that can only be configured at ReStart time.
If one of the functions listed below is needed, now is the time to press
that button and wait for three beeps as confirmation, the
n release the
button.
Beeps Schedule
1 Beep Normal ReStart Sequence
2 Beeps 2-Button (
and ) ReStart
3 Beeps Configuration Confirmation
ReStart and Configuration Functions:
To Next Page
Loading...
