SpectraPure
®
SpectraPure
®
Inc.
480.894.5437 Call us toll-free 1.800.685.2783
2167 East Fifth St, Tempe, Arizona 85281
34
But Could
Not Get
Time From
Network.
Timed-Out,
or Incorrect
Router SSID
or Password.
The LM4 connects properly to the internet,
but there’s a problem getting the time from a
time server. If unsuccessful on the first try, it will
repeat this process until a valid time is received.
Usually, at most, it completes in 2 or 3 tries.
If this error persists, you may have to use the
Private Network and Private IP Address until the
problem can be resolved.
If this screen persists more than approx. 20
seconds, Auto-Connect is probably NOT going
to be successful, for any number of reasons.
Cycle the power to the LM4, or if that is
unsuccessful, then See “
Clear WiFi Parameters”
and the Quick-Start after that to re-establish the
connection with your personal device.
Sometime, there might be a whole-house
power outage. The LM4 will ReStart long before
the local modem/router can return to online
status. The LM4 will wait up to 6 minutes until it
can get a valid connection and time.
There might also be the case where the router
loses power or goes off-line. The LM4’s time will
not be affected, but you may have to reStart the
LM4 to re-establish the connection between the
router and the LM4.
If the router can’t be found, or you waited more
than 6 minutes to configure the WiFi, or there’s
an incorrect SSID or password, the LM4 will
establish itself as a “Private Network” and then
continue to “Normal Operation” without the
network time. This only affects the TIMER and
DELAY Modes.
Reminder: With or without an established
router connection, you can always control
the LM4 using a Personal Device on the LM4-
XXXX Private Network and Browser URL =
192.168.4.1
Network SSID:
LM4-XXXX &
Browser URL:
192.168.4.1
To Next Page
Loading...
