SpectraPure LiterMeter 4 - Toggle Master;Remote Mode

SpectraPure
®
SpectraPure
®
Inc. 480.894.5437 Call us toll-free 1.800.685.2783
2167 East Fifth St, Tempe, Arizona 85281
37
Toggled:
This LM4
is now In
REMOTE Mode
Set Master ID:
- - - - - - - -
LM4- _
Toggled:
This LM4
is now In
MASTER Mode
Release the button. Future ReStarts will have
the LM4 in Remote Mode.
If this is the first time in Remote Mode and this
LM4 has not been “paired” to a Master LM4,
the Remote LM4 will begin slowly chirping
and looking for its mate. Press and hold
the button for two seconds to jump to
“Set Master ID”.
Enter the four digits of the Master LM4’s ID
(viewed whenever the Master LM4 is restarted.)
Use the and buttons to enter the first
digit, move to the right with the button and
continue for all four digits.
Navigate around with the button, then press
button to move to the “S” in “Set”.
Press to return to the “System” page.
ReStart the Remote LM4.
To restore the LM4 to Master Mode, hold the
button down after a ReStart. Hold the button
down until you hear three beeps and you see:
This is an alert that the WiFi credentials
were lost while in Remote Mode and will
need to be re-entered to use the local
router, although a PD can be used with the
private network LM4-XXXX and 192.168.4.1.
See “
Clear WiFi Parameters”.
Remote Mode
Searching for:
LM4-_
‘>’ to Cong.
Network SSID:
LM4-XXXX
Point Browser:
192.168.4.1
Toggle Master/Remote Mode (RIGHT Button ):
See “Using Remote Mode” later in this document. This mode is only
usable when there is another LM4 in Master Mode. When in Remote
Mode, the LM4 communicates directly with the Master LM4, so the
router connection will be toggled off. To configure an LM4 for Remote
Mode, hold the button down directly after a ReStart until you hear
three beeps and you see: