SpectraPure
®
SpectraPure
®
Inc.
480.894.5437 Call us toll-free 1.800.685.2783
2167 East Fifth St, Tempe, Arizona 85281
25
Settings Page on the LM4:
With the Settings page selected, press to move the cursor to the “M”
in “Mode:”. (Later, press to move back up to the current pump.) Press
the or button to move the cursor to the data entry area for Mode:.
Here, press the or buttons to step through the available modes of
operation – OFF, ON, DAILY, DOSE, ONCE, TIMER, and DELAY.
In OFF mode, the pump will not operate but you can set the Flow Rate.
In ON mode, the pump will operate constantly at the selected “Rate:” (in
ml/min). Press or to move the cursor back to the “M” in Mode:. Press
to move the cursor down to the “R” in Rate:. Press or to move to
the data entry area for Rate:. Position the cursor under the digit you wish
to change and press or to change the Rate to any speed between
the maximum and minimum rates that are determined by the Calibrate
procedure. The pump should now be operational. Leave the data entry
area and move back to the “M” in Mode: by pressing either or , or
you can press to change to DAILY mode.
In DAILY mode, the Daily “Total:” (in Liters) and number of Cycles can be
set. This is like the LiterMeter 3 mode of operation. It will dispense a desired
total quantity of liquid every 24 hours using an adjustable number of cycles.
Press or to move the cursor back to the “M” in Mode:. Press to
move the cursor to the “T” in Total:. Press or to move to the “data
entry area” for Total:. Move the cursor under the digit you wish to change
and press or to adjust the Total Liters that you want dispensed each
day. Press or to move the cursor back to the “T” in Total:. Press to
move the cursor to the “C” in Cycles:. Press or to move to the “data
entry area” for Cycles:. There is only one location for the cursor. Press
or to step through the allowable number of cycles per day. Navigation
continues as above. and move the cursor horizontally across the
display, stopping at pertinent locations, and change the values in
data entry areas or moves the cursor vertically between display lines.
Minimum number of Cycles is 2 per day, Maximum Cycles is 720 per day.
NOTE: When setting the values for rate, daily totals, and doses the LM4
will not allow you to set amounts that are greater than the pump’s set rate
can deliver.
To Next Page
Loading...
