SpectraPure
®
SpectraPure
®
Inc.
480.894.5437 Call us toll-free 1.800.685.2783
2167 East Fifth St, Tempe, Arizona 85281
26
In DOSE Mode, the amount (in milliliters) “Each:” dose will dispense and
how often to dispense it can be set. Navigation is similiar to the DAILY
screen - enter mlliliters per dose and select the desired period.
The minutes in DOSE mode or the number of cycles in DAILY mode
must be evenly divisible into 1440 (the number of minutes in a day). For
example, if you set the LM4 for 144 cycles per day, it would dispense every
10 minutes (1440÷144). This data entry area steps up and down through
allowable periods. See “PreSet Periods and Cycles”.
Minimum period is 2 minutes, maximum period is 28 days.
In ONCE mode, ONE total dose (in Liters) will be dispensed at one time.
When that time is now, move the cursor down to the “>” before “START
NOW”. Press to start the pump. The total amount will be dispensed, and
then no further operation will be allowed. Press before “RESTART” to
stop the pump and RESET the total dose. The display will return to “>START
NOW”. If you wished to temporarily “pause” the operation, press . If
a ReStart occurs during a ONCE dose, the dose will not finish. The pump
will RESET to “>START NOW” and return to the top of the “Settings” page.
TIMER mode and DELAY mode need a WiFi connection to maintain the
current time. A Personal Device is also needed to set start and stop times
for the TIMER and DELAY Modes and select one of the three modes to
activate at/after the specified time(s). See “Settings Page on a Personal
Device”. Both allow one of the above three modes (DAILY, DOSE, or
ONCE) to be controlled by the actual time. TIMER sets a daily start and
stop time for a selected mode. DELAY sets a future time to activate the
selected mode. For both time modes, the third line of the display shows
“Start: Select” until one of the three modes is selected. In TIMER mode, if
start and stop times are not set, the fourth line will display “00:00 to 00:00”.
In DELAY mode, the fourth line will display the current time if a mode is
not selected, or the preset future start time if a mode is selected. If the LM4
has not made a connection with a router and time server, the third and
fourth lines will display “Time Not Available”.
Some parameters are shared by multiple Modes. Flow Rate can be set in
the OFF or the ON Mode. The same Flow Rate is also used by the DAILY,
DOSE, and ONCE Modes.
To Next Page
Loading...
