SpectraPure
®
SpectraPure
®
Inc.
480.894.5437 Call us toll-free 1.800.685.2783
2167 East Fifth St, Tempe, Arizona 85281
38
To restore the factory settings, hold the
button down directly after a ReStart.
Hold the button down until you hear three
beeps and you see:
Clear and
Restore to
Factory
Settings
Clear and Restore to Factory Settings (APO Button ):
Parameters that are restored to default factory values include:
Calibration Parameters for All Pumps:
Factory parameters may not always be accurate for a
given pump, but the pumps should operate.
Parameters for All Modes:
DAILY, DOSE and ONCE Modes set to nominal values.
Time Zone, Start, Stop, and Future Times are cleared.
Input Sensor Parameters:
All pumps deselected from inputs and inputs cleared.
Remote Mode restored to Master Mode,
Master ID is cleared.
NOTE: Router Mode and WiFi credentials
(SSID & password) are NOT
affected.
To clear the WiFi Parameters, hold the
button down directly after a ReStart. Hold the
button down until you hear three beeps and
you see:
Clear WiFi
Credentials
SSID = ‘0’
PW = ‘0’
Clear WiFi Parameters (SSID & password) (UP Button ):
This sequence continues on the following page . . .
If you move the LM4 to a new location and/or router, you will have
to clear the parameters before configuring the new router.
Previous
credentials are not saved.
To Next Page
Loading...
