SS1000 Operator’s Manual 2–1
2 - INSTALLATION
Installing the analyzer is relatively easy requiring only a few steps that, when
carefully followed, will ensure proper mounting and connection. Once the
analyzer arrives, you should take a few minutes to examine the contents before
installing the unit.
What Should be Included in the Shipping Box
The contents of the box should include:
• The SpectraSensors SS1000
• This Operator’s Manual with instructions on setting up and operating
the analyzer
• Carrying case
• Membrane separator filter (installed)
• 100–250 VAC, 50/60 Hz battery charger
• Quick-connect fittings for inlet and outlet tubes
• One external serial cable to connect the analyzer to a computer
• Additional accessories or options as ordered.
If any of these contents are missing, contact your sales representative.
Inspecting the Analyzer
Unpack and place the unit on a flat surface. Carefully inspect all enclosures for
dents, dings, or general damage. Inspect the inlet and outlet connections for
damage, such as bent tubing. Report any damage to the carrier.
Hardware and Tools for Installation
Depending on the particular model, the configuration of accessories and
options ordered, you may need the following hardware and tools to complete
the installation process.
Hardware:
• Heated pressure regulator (if inlet pressure is >10 psig or no probe
regulator exists)
Avoid jolting the instrument by dropping it or banging it against a
hard surface. Do not attempt to pick up the instrument using the
sample cell. Either action may disturb the optical alignment.
UK Distibution by IMA Ltd Tel: +44 (0)1943 878877 Email: info@ima.co.uk Web: www.ima.co.uk
To Next Page
Loading...
